Installing threaded inserts Log Out | Topics | Search
Moderators | Register | Edit Profile

Alembic Club » FAQ & Must Reads » FAQ » Information Related to All Instruments » Installing threaded inserts « Previous Next »

Author Message
mica
Moderator
Username: mica

Post Number: 3676
Registered: 6-2000
Posted on Wednesday, October 18, 2006 - 2:46 pm:   Edit Post

On the earliest Alembics, only the battery cover plate had threaded inserts. Some people want to install inserts in other areas on these instruments, and also "Alembicize" other instruments in their arsenal. Carefully read and understand all the nstructions before starting any work.

For truss rod covers and backplates, the inserts are very small 2-56 size. You will need to first make an installation tool from a screw and a spare insert.

Thread the insert with the slots oriented as shown in this picture, leaving about 4 threads exposed below the insert:
tool


Load this assembly on the appropriate allen key for your screw:
tool


And place one drop of superglue to hold it in place:
tool
Make sure you keep the glue off of the exposed threads or you won't be able to load the insert for installing on it.

Wait at least an hour to make sure the glue has hardened before using the tool.
mica
Moderator
Username: mica

Post Number: 3677
Registered: 6-2000
Posted on Wednesday, October 18, 2006 - 3:09 pm:   Edit Post

Now that your insertion tool is prepared, you can start installing the inserts on your instrument.

Here's a Further guitar without any holes for mounting the truss rod cover:
insert instructions


With the plate in place, drill the 3/32" pilot holes:
insert instructions


Remove the plate:
insert instructions


Drill to 1/8" finished hole size:
insert instructions



Load threaded insert on tool. Notice the orienation of the "slots" - they are the entry end of of insert (and opposite of the way you made the tool):
insert instructions


Use the allen key on your tool to install the insert.
insert instructions



It's okay if you install them a little deep - the screws will still reach them, but it looks nicest when they are near flush:
insert instructions


Some notes: do not use any glue on the installed insert unless the hole is too large. Even then you must be extremely careful because if you get glue on the interior threads, your machine screws won't be able to enter the insert.

When you are making the insertion tool, allow the glue to dry for a good hour before using.

Even though it looks like you could use a screwdriver to install the insert, it was not designed for this method. The tabs on either side of the slot cannot withstand the force of insertion.
insert instructions

It's also not a terrible idea to practice on a scrap of wood before taking this to your precious instrument.
mica
Moderator
Username: mica

Post Number: 3680
Registered: 6-2000
Posted on Wednesday, October 18, 2006 - 3:49 pm:   Edit Post

For the regular 4-hole pickup mounting screws, we use a 6-32 insert, a 1/8" pilot hole and a 3/16 final hole size.

For 2-hole guitar pickups, we use a 4-40 insert, a 1/8" pilot hole and a 3/16 final hole size.

For best alignment on pickups, drill right through the holes in the pickups for the pilot holes as illustrated for the truss rod cover.

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Last Week | Tree View | Search | Help/Instructions | Program Credits Administration