Replacing input jack... Log Out | Topics | Search
Moderators | Register | Edit Profile

Alembic Club » Alembic Basses & Guitars » Archive: 2008 » Archive through April 06, 2008 » Replacing input jack... « Previous Next »

Author Message
skydigger
Junior
Username: skydigger

Post Number: 22
Registered: 11-2007
Posted on Sunday, February 10, 2008 - 2:43 pm:   Edit Post

I have a set of Alembic P activators and the jack that is on the harness will require routing to install on my bass.

Can I replace the Alembic jack with a regular Switchcraft jack?
davehouck
Moderator
Username: davehouck

Post Number: 6194
Registered: 5-2002
Posted on Sunday, February 10, 2008 - 8:31 pm:   Edit Post

The standard top mount Alembic jack is a Switchcraft L113. It looks like this. Is that what you have?
skydigger
Junior
Username: skydigger

Post Number: 23
Registered: 11-2007
Posted on Monday, February 11, 2008 - 4:51 am:   Edit Post

Yeah, thats the one. I didn't realize that it was Switchcraft as well...

I guess a side mount jack should be no problem then???
davehouck
Moderator
Username: davehouck

Post Number: 6195
Registered: 5-2002
Posted on Monday, February 11, 2008 - 8:12 am:   Edit Post

The L113 is not listed on the page I linked; but it's the same as the 113 except that the shaft is longer to fit through the top of a guitar (rather than a piece of sheet metal). The schematic for the L113 is number "V" on this page. As you can see on that page, not all jacks are the same. If I understand/remember correctly, the "make" circuit on the L113, breaks the ciruit to the battery when the instrument is unplugged, saving battery life.

How far off is the jack from fitting in your bass? If it's off by just a little, you may be able to bend the spades that the wires are soldered to, carefully, with a couple of needle nose pliers. If you have a camera handy, some pictures might help; some of the folks around here might have some suggestions if they can see what the problem looks like.
spose
Intermediate Member
Username: spose

Post Number: 185
Registered: 5-2002
Posted on Monday, February 11, 2008 - 9:35 am:   Edit Post

is this going into a FENDER P Bass?
if so, did you have to route space for the 9 volt battery?

thanks
skydigger
Junior
Username: skydigger

Post Number: 24
Registered: 11-2007
Posted on Monday, February 11, 2008 - 3:00 pm:   Edit Post

The jack is WAY too far out. I either need to route or replace the jack.

Right now I mainly play flamenco guitar. I've had this pickup for years and never did anything with it. When i bought it, it retailed for $450. Now I see Alembic is charging $750 for it!!

So, I decided to by a CHEAP-ass bass and install the Alembic activator. It's not a Fender and no additional routing is required...

Come to think of it, this bass is a P\J, so I might be able to remove one of the controls for the jazz pickup (which won't be used) and mount it on the top after all.

I didn't realize it was meant to be top mounted...

Thanks for the help...

Topics | Last Day | Last Week | Tree View | Search | Help/Instructions | Program Credits Administration