| Author | Message | ||
| japhy4529
New Username: japhy4529 Post Number: 7 Registered: 6-2015 |
I feel silly asking this question, but here it goes... I'm trying to change the battery in my 95' Alembic Elan 5. I've removed the screws from the back control plate (where the battery and preamp are located), yet it is such a tight fit that I cannot remove it from the body! I don't want to risk damaging the wood. I've turned the bass over and have lightly tapped on the bass (with no luck) and I've used my fingernails. It's not even budging. Any ideas? Thanks, Tom | ||
| jimmyj
Senior Member Username: jimmyj Post Number: 641 Registered: 8-2008 |
Perhaps "duct tape" is the answer ... to everything. Ha! Jimmy J | ||
| ed_zeppelin
Advanced Member Username: ed_zeppelin Post Number: 321 Registered: 2-2010 |
I use a plastic putty knife because it has a wide flat surface. Don't worry, you're not going to pry with it.  Tape the tip of the blade flat to the brass plate with duct tape or masking tape. At the edge of the plate, on the body, place a cloth or folded-over paper towel for protection, and something flat (I use a carpenter's pencil because they're flat, so they don't roll away when you set them down) to use as a fulcrum. Just a slight nudge downward on the handle of the putty knife is all it takes. You can even twist the handle sideways if you need to, as long as you don't let the fulcrum slide around. Cleanup any tape residue with a dab of rubbing alcohol on a paper towel. | ||
| gtrguy
Senior Member Username: gtrguy Post Number: 1043 Registered: 9-2004 |
I have a dentist pick that I put into the screw hole and pry a bit on the cover. The plate needs to come up evenly, so a couple of holes on each end a little at a time might do it. OR - duct tape, as above! I use goo gone if any residue is left (or use the nice blue masking tape). Or try it in the early morning when the bass is colder (leave the case open overnight, keep away from the pets). | ||
| growlypants
Intermediate Member Username: growlypants Post Number: 167 Registered: 3-2011 |
Wow! I thought only I had this "problem"!! (Scotch tape does the trick for me) | ||
| japhy4529
New Username: japhy4529 Post Number: 8 Registered: 6-2015 |
You guys are the best. I will try one or more of these tricks tonight and report back with the results. I've actually placed this bass on the Talkbass.com classifieds as a possible trade. However, after playing her for a couple of hours last night, I'm not sure if I can go through with it. Sounds incredible! | ||
| jazzyvee
Senior Member Username: jazzyvee Post Number: 4977 Registered: 6-2002 |
I still love your Elan. I hope you keep it until i can justify buying it. :-) | ||
| lbpesq
Senior Member Username: lbpesq Post Number: 6407 Registered: 7-2004 |
FWIW, I use the smallest size in my mini screwdriver set to pry up the backplate using the screwdriver in one of the empty screw holes, not unlike David's dental pick method. Bill, tgo | ||
| japhy4529
Junior Username: japhy4529 Post Number: 12 Registered: 6-2015 |
The duct tape ("duck tape" in this case) trick worked like a charm. My 10-year old daughter suggested placing two pieces (one on top of the other) on the plate and that Finally got it done. @jazzyvee - Funny! I don't think I'll be able to let her go after all. I'll definitely let you know if I change my mind. Thanks, Tom |
