My F-2b died Log Out | Topics | Search
Moderators | Register | Edit Profile

Alembic Club » Owning an Alembic » Troubleshooting » Archive through November 30, 2011 » My F-2b died « Previous Next »

Author Message
murphy
New
Username: murphy

Post Number: 1
Registered: 11-2010
Posted on Tuesday, November 02, 2010 - 8:02 pm:   Edit Post

Black frame red knob version.
I have no power light come on. No sound.
Tried changing the fuse, still nothing.
I sent a mesage to service, but haven't had a reply yet.
Does anyone have any ideas?
Thanks for any help you can offer
edwin
Senior Member
Username: edwin

Post Number: 792
Registered: 5-2002
Posted on Wednesday, November 03, 2010 - 12:37 am:   Edit Post

I wonder if the power cable might have a break in it somewhere. It's a pretty simple circuit. A dumb question, but do you know that the replacement fuse is good (I've tried to trouble shoot things only to find that the replacement part is also bad.)?
murphy
New
Username: murphy

Post Number: 2
Registered: 11-2010
Posted on Wednesday, November 03, 2010 - 11:04 am:   Edit Post

Well after a week of not working, it is suddenly working again.
Even stranger????? Any other thoughts?
davehouck
Moderator
Username: davehouck

Post Number: 9790
Registered: 5-2002
Posted on Wednesday, November 03, 2010 - 11:45 am:   Edit Post

As Edwin suggested, a good place to start is with a visual inspection of the power cable. Are the prongs on the plug end solid, not loose? Is there any fraying of the cable at the plug end? Any fraying where the cable passes through the chassis? Are the connections from the cable to the components inside the chassis in good condition?

Note: unplug the cable before opening the chassis; and remember that even unplugged there are components in the chassis that can cause serious electrical shock.

With the cable unplugged, you can also use a multimeter to check that current is running through each of the wires of the power cable from the prongs to the chassis connections.

You might also check to see if the fuse is seated properly.
murphy
New
Username: murphy

Post Number: 3
Registered: 11-2010
Posted on Wednesday, November 03, 2010 - 12:07 pm:   Edit Post

Thank you ,thank you, thank you
You guys are right.

It must be the power cable, as It cuts in and out when I move the cable around.....

must be because it is so old and fatigued inside the insulation.It is serial number 874.

So now all I have to do is go to the hardware store and buy a new power cord.

I am so relieved and was so upset that my beloved Alembic was not working.


(Message edited by murphy on November 03, 2010)
murphy
New
Username: murphy

Post Number: 4
Registered: 11-2010
Posted on Sunday, November 14, 2010 - 12:32 pm:   Edit Post

Just to report new power cable installed and all is well.
davehouck
Moderator
Username: davehouck

Post Number: 9824
Registered: 5-2002
Posted on Sunday, November 14, 2010 - 6:30 pm:   Edit Post

Great!

Topics | Last Day | Last Week | Tree View | Search | Help/Instructions | Program Credits Administration