Series I at Gruhn Guitars Log Out | Topics | Search
Moderators | Register | Edit Profile

Alembic Club » Swap Shop and Wish Lists » Seen on craigslist, eBay, and elsewhere » Archive 2006 » Archive through August 14, 2006 » Series I at Gruhn Guitars « Previous Next »

Author Message
57basstra
Intermediate Member
Username: 57basstra

Post Number: 136
Registered: 4-2005
Posted on Monday, July 03, 2006 - 6:45 pm:   Edit Post

Gruhn Guitars in Nashville has this Series I in their inventory as consignment. They say they are firm on the $4,000 price right now. What up with the upper horn? I talked with a guy, not George, who said the serial number (partial) is 194....I wonder if he is like me and can't see well. I will assume it is a 1994. Has this one been discussed before? how far off are they on the price? Gruhn Guitars also has an Epic 4 fretless at $2,500.

Gruhn Series
bsee
Senior Member
Username: bsee

Post Number: 1218
Registered: 3-2004
Posted on Monday, July 03, 2006 - 7:20 pm:   Edit Post

Could be a 94, but serial numbers start with only the last two digits of the year, so it would be 94XXXX, not 194XXX. It looks like the serial number is on the truss rod cover, so it isn't particularly old. I would think that $4K for a 90s Series bass in excellent condition is a reasonable price from a dealer. You might expect to do a couple hundred better in a private sale, but not too much. Two years ago, $3K in a private sale would have been about right, but used Alembics have been creeping up in value.

just my view...
57basstra
Intermediate Member
Username: 57basstra

Post Number: 137
Registered: 4-2005
Posted on Monday, July 03, 2006 - 8:06 pm:   Edit Post

Bob, I have not seen a Series that had that type of contour with the upper horn? What is that modification called?
bsee
Senior Member
Username: bsee

Post Number: 1219
Registered: 3-2004
Posted on Monday, July 03, 2006 - 8:11 pm:   Edit Post

I couldn't say for sure, but I know there were some Mark Kings made in a "balance" style adjusted to improve the way the bass hangs. The lengthening of the upper horn would be the way to accomplish that. I would guess this is a Series bass made with that same "balance" body style.

Now we have the "Balance K", which is much more attractive to my eye.
57basstra
Intermediate Member
Username: 57basstra

Post Number: 139
Registered: 4-2005
Posted on Monday, July 03, 2006 - 8:15 pm:   Edit Post

At first I really did not care for this particual body style; but the more I have looked at it admired the beautiful figured wood, I have really grown to like the looks of the bass. I hope someone can tell me something about the upper horn 'persuasion' on this instrument. I have looked on the links as best I can and have not found anything yet. I'm still looking, though. The guy at Gruhn Guitars couldn't tell me much at all.
bigredbass
Senior Member
Username: bigredbass

Post Number: 873
Registered: 9-2002
Posted on Monday, July 03, 2006 - 11:53 pm:   Edit Post

I've seen this shape where they added a Distallate-looking horn no doubt to try and add a little balance to the Series long scale axes.

What really jumps out at me about this is it almost looks like the maple-recipe 20th Anniversary (all the quilt and purpleheart) in a point body with Signature (I think) electronics.

I'll ease down to Gruhn's Wednesday, test drive them and nab the serial #s.

When am I EVER gonna run across something like this in a FIVE?!?!?

J o e y
bigredbass
Senior Member
Username: bigredbass

Post Number: 874
Registered: 9-2002
Posted on Monday, July 03, 2006 - 11:55 pm:   Edit Post

I'm a nitwit: It's CERTAINLY Series electronics.

J o e y
davehouck
Moderator
Username: davehouck

Post Number: 4031
Registered: 5-2002
Posted on Tuesday, July 04, 2006 - 10:05 am:   Edit Post

I'm guessing here, but technically, I don't think it's a balance point body; I think it's a standard point body with a Distillate upper horn (or a Distillate body with a point). I'm thinking that on a balance point, the horn doesn't curve back in the way a Distillate horn does. Either way, it should balance better than a typical standard point. I would guess this was a custom order, which may explain the positioning of the pickup selector switch in the old position. And I can't remember about the round battery cavity cover; but I'm guessing that, plus the pickup switch position, plus the nice quilt, might put this bass around 1985.
olieoliver
Senior Member
Username: olieoliver

Post Number: 525
Registered: 2-2006
Posted on Tuesday, July 04, 2006 - 11:34 am:   Edit Post

I have a Mk with the same extended upper horn and it balances and plays like a dream, even better than my Balnce K. The Balance K is lighter though.
bigredbass
Senior Member
Username: bigredbass

Post Number: 879
Registered: 9-2002
Posted on Wednesday, July 05, 2006 - 5:02 pm:   Edit Post

OK, I went to Gruhn's today.

The Series is in its original case, with the small power supply, a ratty looking 5-pin cable, and an envelope full of correspondence and catalog ($6500 for a new S-I !) from the address in Santa Rosa.

The serial number I didn't understand: It's on the (kinda dented) truss rod cover and says
1 9 4 6, spaced out like that with no other numbers or letters.

The whole thing is just ratty enough where it's not sorta mint, yet not dog-beat-up bad. Just enough dings and dents to be kinda average minus if I had to put a condition on it. Real shame. It appears to be a satin finish yet looks glossy in spots that's not left over finish or shiny from body contact. Strange. The bird tailpiece appears to have been re-sanded/polished by some owner, then dipped into a can of poly, it's real thick.
Lots of dings and dents around the lower edge.
Could not plug it in, so I have no clue about the electronics.

When I buy used, I like clean finish save for cleaning and polishing, with some elbow grease for the brightwork and a little setup work. This Series would need finish rework to be to that point. It's a consignment, so they're understandably firm at $4K, but I wouldn't be a player for it at that price vs. condition.

The Epic Fretless 5 is in MUCH better shape, VERY clean save for a small nick in the satin finished back that a shirt button would cover, with its case (lot rougher than the axe, but useable.) Could not get a serial as someone wanted to see it. Unlined fretless, all dark woods, had 'mwah' wrote all over it! Vol, bal, treb, bass.

J o e y
davehouck
Moderator
Username: davehouck

Post Number: 4038
Registered: 5-2002
Posted on Wednesday, July 05, 2006 - 5:57 pm:   Edit Post

Thanks for that report Joey!!
dfung60
Intermediate Member
Username: dfung60

Post Number: 185
Registered: 5-2002
Posted on Wednesday, July 05, 2006 - 11:08 pm:   Edit Post

For what it's worth, I think this is a Series I from the mid 80's. The pickups look like the ones from this period - smooth black tops embossed with "Alembic". Earlier than that and there's nothing on the pickups; by the 90's they had the gold foil logo instead. The pickup selector is out on the lower bout, which was also the standard through the mid 80's.

I think the big upper horn is also an 80's thing. I remember when I had my first custom built, that there were a number of evolutionary changes that I was not that crazy about. One of them definitely was the bigger upper horn, although I can't remember whether this is what it looked like; only that it was pretty different. The other changes were things like a thinner body and the embossed pickups. I had them do the original body shape, although that bass (it's a 1987 Series II but it was a long time in construction because it was a graphite neck) does have the thin body and embossed pickups. I remember that the changed body shape was in there literature at least once, but I don't remember seeing many of these basses around.

David Fung
adriaan
Senior Member
Username: adriaan

Post Number: 958
Registered: 6-2002
Posted on Thursday, July 06, 2006 - 1:14 am:   Edit Post

There was a mid-80s vermillion topped 5 string S1 for sale at Edwin van Huyk's place a year or two ago, with much the same shape to the upper horn.
57basstra
Intermediate Member
Username: 57basstra

Post Number: 147
Registered: 4-2005
Posted on Thursday, July 06, 2006 - 7:14 am:   Edit Post

Wonder what's up with the 1 9 4 6 number (serial??) on the truss rod cover? Where else would the serial number be?
bsee
Senior Member
Username: bsee

Post Number: 1221
Registered: 3-2004
Posted on Thursday, July 06, 2006 - 8:37 am:   Edit Post

Serial number 1946 would fall around 1981. That would mean the serial number should be pressed into the fretboard below the 24th fret. That, of course, assumes that 1946 is the actual serial number.
adriaan
Senior Member
Username: adriaan

Post Number: 959
Registered: 6-2002
Posted on Thursday, July 06, 2006 - 8:55 am:   Edit Post

People have had special engravings done on truss rod covers before - it needn't be the serial number ...

Topics | Last Day | Last Week | Tree View | Search | Help/Instructions | Program Credits Administration