Author |
Message |
alembickoa
Intermediate Member Username: alembickoa
Post Number: 103 Registered: 5-2002
| Posted on Thursday, August 16, 2012 - 9:04 pm: | |
I would love to get a brass truss rod cover for the Orion and have it engraved with something specific. Should I go to our local dealer and place the order there or is it ok to radio the Mothership directly to place the order? Any advice is welcome. Blessings...Steve |
jacko
Senior Member Username: jacko
Post Number: 3236 Registered: 10-2002
| Posted on Friday, August 17, 2012 - 4:08 am: | |
I asked Mica the same question a few years ago when I wanted a brass truss rod cover for my epic. I've lost the email reply but I do recall I would have to have sent the plastic one back so that they got the holes drilled I the correct place. I can't remember the cost but I guess it was more than I could afford at the time as I didn't proceed. Graeme |
davehouck
Moderator Username: davehouck
Post Number: 10863 Registered: 5-2002
| Posted on Friday, August 17, 2012 - 9:47 am: | |
Like Graeme, my recollection too is that it is not as straightforward as you might think. So yes, contact the shop. |
mica
Moderator Username: mica
Post Number: 7843 Registered: 6-2000
| Posted on Friday, August 17, 2012 - 4:14 pm: | |
It's not simple, but if you were coming by, and we knew in advance, we could fabricate one for you in a couple of hours. Engraving can't be done that quickly, but you could take it to any trophy shop or mall for the engraving. |
alembickoa
Intermediate Member Username: alembickoa
Post Number: 107 Registered: 5-2002
| Posted on Friday, August 17, 2012 - 10:23 pm: | |
Thank you, Mica...I am having an urge to venture north of the big orange bridge and possible end up in Alembicville. I will let you know, for sure. |