| Author | Message | ||
| jdog_35
New Username: jdog_35 Post Number: 1 Registered: 1-2008 |
I have a bt-350 crate bass head running a 8-ohm black widow 15 cab at 250 watts. I have all the low and mids you could ask for. I want to added a 4-10 cab at 8-ohm to get to a 4-ohm 350 watts rms. will this kill my vol at 175-175 rms ? I need some higher notes to get out of muddy sounds. | ||
| keavin
Senior Member Username: keavin Post Number: 1345 Registered: 12-2002 |
actually you'll get everything the amp has to offer @ 4ohms including extra highs!.....im currently running two bag-end cabs w/JBL 15's @300 watts rms!/Gallien-Kreuger Amp.i personally prefer 15's over 12's..  (Message edited by keavin on January 29, 2008) | ||
| adriaan
Senior Member Username: adriaan Post Number: 1770 Registered: 6-2002 |
Here's the manual - check pages 6 and 8. You cannot run an 8 ohm cab with a 4 ohm cab on the speaker outputs, because the total load is in parallel, and those two cabs in parallel are less than 3 ohms, whereas the amp needs 4 ohms - anything below that will fry up the amp. The bi-amp option lets you use the BT350 as the power amp for either the high or the low frequencies, and you need a separate power amp for the other part - it's all explained on page 8. | ||
| jdog_35
New Username: jdog_35 Post Number: 2 Registered: 1-2008 |
I have a old Fender Music master bass ser# 548565.my dad bought it fairly new. He decided that paint was looking bad and painted over the original paint.Is there any way to take the new paint off? | ||
| jdog_35
New Username: jdog_35 Post Number: 3 Registered: 1-2008 |
thank you for your time and answers |
