| Author | Message | ||
| jx2638
Member Username: jx2638 Post Number: 56 Registered: 2-2008 |
Is it possible to effectively power a Mutron III with two 9 volt leads running directly from the power supply on my pedalboard to the two internal 9 volt battery connectors...instead of using a 3 pin PS-1 power supply? | ||
| tom_z
Senior Member Username: tom_z Post Number: 598 Registered: 7-2004 |
That's a great question - I would also like to know if anyone has successfully done this. When I acquired my Mutron III it had no power supply and it eats batteries like a pig. I was able to purchase a PS-1 power supply from Lingenberg Sound. | ||
| terryc
Senior Member Username: terryc Post Number: 1105 Registered: 11-2004 |
As long as the milliamp rating matches up to the pedal..I would guess at 300mA for most pedals. | ||
| jx2638
Member Username: jx2638 Post Number: 57 Registered: 2-2008 |
(Message edited by jx2638 on October 09, 2009) | ||
| jx2638
Member Username: jx2638 Post Number: 58 Registered: 2-2008 |
The out jacks on the power supply are all 9 volt x .25A. There are also three 18 volt x .35A out jacks. Familiar with after market PS-1's (CAE too) but wondered if you could save the $70 by going battery compartment route. |
